Heli Pad‎ > ‎The CH54 Aircrane‎ > ‎

CH54 Design and Build Page 3

























This was just a test to see if I could get everything clamped and aligned correctly. I determined it would be extremely
hard to get all the stringers and bulkheads lined up and in place all in one shot. So a new plan was needed. I did however
use this method to glue the top two stringers in place. This would also help in alignment of the bulkheads as they are cut
to fit a certain width only. You can see in the photo below how the top stringers are glued and held in place.